Rockwell k56flex
Rockwell k56flex
AT&FV1W1X4&C1&D3&K3\N3%C3S7=60
AT: (beginning of most inits) Attention!
&F: Sets the values loaded in the active profile to the values that are set in the default profile.
V1: This command sets the format for information-text and result codes to Word (verbose) format
W1: Enables the CONNECT result codes to report the DTE speed.
X4: Busy and dialtone detection enabled. Result codes 0-7,10 enabled.
&C1: DCD enabled after a carrier signal is detected
&D3: DTR drop causes the modem to be reinitialized
&K3: Enable RTS/CTS flow control
\N3: Auto-reliable or MNP auto-reliable mode
%C3: This command selects the data compression to both MNP5 and v.42bis
S7=60: Wait at least 60 seconds for carrier before discontinuing connection attempt.
This page was last modified on Saturday, 05-Feb-2011 15:13:13 EST.
|
