RPI 1st generation WITH DRIVERS String Explaination
RPI 1st generation WITH DRIVERS
AT&F&C1&D2&K3&Q5+H3S95=1
AT: (beginning of most inits) Attention!
&F: Sets the values loaded in the active profile to the values that are set in the default profile.
&C1: DCD enabled after a carrier signal is detected
&D2: DTR drop causes modem to hang up
&K3: Enable RTS/CTS flow control
&Q5: Error correction mode
+H3: Enable RPI and set computer speed to 57600 bps
S95=1: Use DCE when reporting CONNECT result codes
This page was last modified on Saturday, 05-Feb-2011 15:13:13 EST.
|
